Rating 4.68 out of 5 (93 ratings in Udemy)
What you'll learn- VFD (Inverter Drive) theory of operation, volts per hertz, flux vector, pumps & fan mode applications explained.
- Drive specifications and power requirements.
- VFD and motor installation considerations.
- Inverter duty motors, line and load reactors and braking resistor requirements explained.
- Learn about applications that would benefit from utilizing VFD technology.
- VFD safety considerations and lock out.
- Auto-tuning, motor …
Rating 4.68 out of 5 (93 ratings in Udemy)
What you'll learn- VFD (Inverter Drive) theory of operation, volts per hertz, flux vector, pumps & fan mode applications explained.
- Drive specifications and power requirements.
- VFD and motor installation considerations.
- Inverter duty motors, line and load reactors and braking resistor requirements explained.
- Learn about applications that would benefit from utilizing VFD technology.
- VFD safety considerations and lock out.
- Auto-tuning, motor parameter set up, 2-wire control, 3-wire control, analog speed and multiple digital speeds, jog mode, and drive response to power failure.
- Introduction and use of PC based drive setup software to configure the drive.
- Maintenance, diagnostic and troubleshooting, fault codes and drive monitoring covered.
- Reforming DC bus capacitors after long term storage procedures covered.
DescriptionThis course covers all aspects of working with modern variable frequency drives (VFDs).
Generic terms that apply to all VFD manufacturers are covered. Wiring, programming and commissioning of different manufacturers are covered. In depth VFD setup is covered using professional drive commissioning software that is included free in the course. The student can follow along and adjust parameters using the software. Also included and demonstrated is VFD simulation software that replicates exactly the front panel buttons of a modern VFD. The student is walked through the steps of setting up a drive and important points learned over the years are covered. Periodic inspection and maintenance of VFDs and electric motors is covered. The tasks involved in maintaining and troubleshooting equipment are covered.
Other important information covered in the course include:
Working safely with VFDs and the hazards associated with VFD commissioning
VFD power and control wiring
Line, load and DC link reactors
The DC bus
Sink & source wiring
VFD digital and analog inputs and outputs
VFD motor braking
Inverter rated motors
Motor turn down ratios
Basic VFD theory of operation
Basic Motor theory of operation
Constant torque and variable torque modes
Volts per hertz ratios
Pump & fan applications
Auto-tuning
VFD wiring schematics are explained and demonstrated with design software
2-wire control transition and run at power up
3- wire control with forward and reverse
