JN0-362 (JNCIS-SP) Juniper Exam Certification Tests Updated
Exam Service Provider Routing and Switching Specialist (JNCIS-SP) :-
JNCIS-SP exam designed for experienced networking professionals with beginner to intermediate knowledge of routing and switching implementations in Junos, this written exam verifies the candidate’s basic understanding of routing and switching technologies and related platform configuration and troubleshooting skills.
This practice test exams will give you full confidence to pass the Juniper JNCIS-SP Exam.
Juniper (JNCIS-SP) Exam Sample Questions :-
Q-1 What happens when a packet matches a static route with the next hop parameter set to reject?
A. The system silently drops the packet
B. An ICMP message is sent to the source and the packet is forwarded
C. An ICMP message is sent to the source and the packet is dropped
D. The packet is forwarded and the packet is marked as rejected in the header
Q-2 Which two statements describe operations performed by the encapsulating tunnel endpoint in an IP-IP tunnel? (Choose two.)
A. It decrements the time-to-live (TTL) counter by one in the inner IP header
B. It modifies the source and destination addresses in the inner IP header
C. It adds an outer IP header with the destination address of the remote tunnel endpoint
D. It creates and adds a new inner IP header with the remote destination device’s IP address
Q-3 When working with an MPLS LSP, what will the install 172.16.6.0/24 active command accomplish?
A. The command will swap the prefix from inet.0 to inet.3
B. The command will swap the prefix from inet.3 to inet.0
C. The command will install the prefix in inet.0 rather than inet.3
D. The command will install the prefix in inet.3 rather than inet.0
Q-4 Which IPv6 extension header notifies intermediary devices that they must inspect the packet’s options?
A. destination options header
B. routing header
C. hop-by-hop options header
D. fragment header
Q-5 You are asked to change the default TTL handling behavior on your Junos device to ensure that the RSVP-signaled LSPs in your MPLS network cannot be mapped. Which configuration should be performed to accomplish this task?
A. Configure the no-decrement-ttl parameter for each LSP on the ingress device
B. Configure the no-propagate-ttl parameter for each LSP on the egress device
C. Configure the no-propagate-ttl parameter for each LSP on the ingress device
D. Configure the no-decrement-ttlparameter for each LSP on the egress device
