Are you ready to pass the CCNP Enterprise 300-410 ENARSI Exam certification ?

This exam helps prepare you to take the exam, 300-410 Implementing Cisco Enterprise Advanced Routing and Services (ENARSI), which leads to the new CCNP Enterprise and Cisco Certified Specialist – Enterprise Advanced Infrastructure Implementation certifications.

This exam certifies a candidate's knowledge for implementation and troubleshooting of advanced routing technologies and services including Layer 3, VPN services, infrastructure security, infrastructure services, and infrastructure automation.

300-410 ENARSI Exam Sample Questions :-

Q-1 . Which protocol is used to determine the NBMA address on the other end of a tunnel when mGRE is used?

A. NHRP

B. IPsec

C. MP-BGP

D. OSPF

Q-2 Which configuration enables the VRF that is labeled “Inet” on FastEthernet0/0 ?

A. R1(config)# ip vrf Inet

R1(config-vrf)#ip vrf FastEthernet0/0

B. R1(config)#ip vrf Inet FastEthernet0/0

C. R1(config)# ip vrf Inet

R1(config-vrf)#interface FastEthernet0/0

R1(config-if)#ip vrf forwarding Inet

D. R1(config)#router ospf 1 vrf Inet

R1(config-router)#ip vrf forwarding FastEthernet0/0

Q-3 Which statement about route distinguishers in an MPLS network is true?

A. Route distinguishers allow multiple instances of a routing table to coexist within the edge router.

B. Route distinguishers are used for label bindings.

C. Route distinguishers make a unique VPNv4 address across the MPLS network.

D. Route distinguishers define which prefixes are imported and exported on the edge router.

This practice test exam CCNP Enterprise 300-410 ENARSI will give you full confidence to pass the main official Cisco exam.