Sample Questions:
What are two of the commands that you can enter to gracefully shut down OSPF and notify neighbors? (Choose Two)
router(config-if)#ip ospf graceful shutdown router(config)#ip notify
router(config-router)#shutdown
router(conf-router)#graceful shutdown
router(config-if)#ip ospf shutdown
Which two conditions are required for tracking the interface IP routing state? (Choose two)
A VRF must be enabled on the interface. IP routing must be disabled on the interface.
Cisco Express Forwarding must be disabled on the interface.
The interface line protocol must be up.
A known IP address must be configured on the interface.
Which statement about OSPF loop prevention is true?
The discard route is generated automatically on the ABR to prevent routing loops.
The ASBR uses type 3 LSAs from non-backbone areas to prevent control-plane routing loops.
The ABR can filter type 3 LSPs to prevent routing loops.
The DN bit ignores LSA types 2, 3, and 5 to prevent routing loops.
Which value does EIGRP use to determine the metric for a summary address?
The average of the component metrics
A default fixed value
The lowest metric among the component routes
The highest metric among the component routes
Which two statements about IPsec VTI implementation are true? (Choose two.)
The IKE SA can be bound to the VTI and the crypto map.
The transform set can be configured only in tunnel mode.
SVTIs support only a single IPsec SA.
SVTIs support IPv4 packets that carry IPv6 packets.
What are two benefits of Per-Tunnel QoS for DMVPN? (Choose two.)
The administrator can configure criteria that, when matched, can automatically set up QoS for each spoke as it comes online.
Traffic from each spoke to the hub can be regulated individually.
When traffic exceeds a configurable threshold, the spokes can automatically set up QoS with the hub.
The hub can send large packets to a spoke during allotted timeframes.
The hub can be regulated to prevent overloading small spokes.
Which IP SLA operation requires Cisco endpoints?
UDP Jitter for VoIP
ICMP Path Echo
ICMP Echo
UDP Jitter
